Miele G 7883 CD - Troubleshooting Water Softener and Intake Issues

What if... Possible fault Solution
The "Recharge"
indicator flashes.
The water softener has run
out of salt.
Refill the salt reservoir.
A few minutes after the
start of a program, the
"Fill/Drain" indicator
flashes, and the
program stops.
Before addressing the
error:
–
Turn the program
selector to f. The error
message is erased.
–
Press the On-Off button
to switch off the
machine.
Error message: F..E:
There is a problem with the
water intake.
–
Open the water valve
completely.
– Clean the water inlet
filters.
– The flow pressure at the
water connection is too
low. Contact a qualified
plumber for advice.
Then:
– Switch the washer on.
– Restart the program.
Frequently asked questions
57