Technical Information
111
G 600/G 800
Example:
Sani Wash: 007
Normal 150: 127
Total operating hours: 7.127 hours
6.8.9 G 892, G 832
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Heated drying (on/off)
Enter Service Mode 1
To access:
Manual step mode
Component test program
Enter Service Mode 2
To access:
Error messages
Program index number
Increased water temperature selection
Water softener (with/without)
Extended water intake
Extended drying fan time
Dishwasher width setting
EGS
Table 6-45: G 892, G 832 Programming Flow Chart
6.8.9.1 Programming Mode
1. To access the programming mode, close the door and turn the dishwasher on.
The Start/Stop light must be blinking. If the Start/Stop light is not blinking, press
and hold the Start/Stop button for at least 3 seconds to exit the cycle. The
Start/Stop light should now be blinking.
2. Turn the dishwasher off.
3. Press and hold the Start/Stop button while turning the dishwasher on. Release
the Start/Stop button within 2 seconds. Successful accessing of the
programming mode is indicated by a blinking Salt light and a lit or flashing
Rinse light.
Note:
If the Rinse light is neither lit nor flashing, the machine has been programmed
to “without softener”. See Service Mode 2 (Section 6.8.9.3) to turn the water
softener on or off.
6.8.9.1.1 Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Using Table 6-46 below, press the down arrow button to choose the corresponding
program for setting the correct water hardness (e.g., “Normal Plus” = 8 to 11 gpg).
To Next Page
Loading...
Need help?
General
