Technical Information
119
G 600/G 800
6.8.11.1 Programming Mode
1. To access the programming mode, close the door and turn the dishwasher on.
The Start/Stop light must be blinking. If the Start/Stop light is not blinking, press
and hold the Start/Stop button for at least 3 seconds to exit the cycle. The
Start/Stop light should now be blinking.
2. Turn the dishwasher off.
3. Press and hold the Top solo and Start/Stop buttons while turning the
dishwasher on. Successful accessing of the programming mode is indicated by
a blinking Salt light.
4. The display will show the current water hardness setting. The “A” indicates
Aqua and the numbers indicate the hardness setting.
Note:
If the display is blank, the appliance has been programmed to “without softener”.
See Service Mode 2 (Section 6.8.11.3) to turn the water softener on or off.
6.8.11.1.1 Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Using the arrow buttons, enter the correct water hardness setting.
4. To save: Press the Start/Stop button twice.
6.8.11.1.2 Extended Drying Fan Time
1. Access Programming Mode.
2. Press the Top solo button once. The End light will light up.
3. Use Table 6-58 below to determine the drying fan time.
4. Press the Top solo button to toggle from 4.5 minutes to 14 minutes.
5. To save, press the Start/Stop button twice.
Program light Options Status of program light
Pots & Pans
4.5 minutes Flashing
14 minutes Lit
Table 6-58: G 896 Drying Time Settings
6.8.11.2 Service Mode 1
1. To access Service Mode 1, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and
hold the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop
light should now be blinking.
2. Press the Top solo and Delay Start buttons while turning the dishwasher on.
Successful accessing of Service Mode 1 is indicated by lit Intake and Drain
lights and a flashing Start/Stop light.
3. Using the arrow buttons, select a program and press the Start/Stop button.
4. Pressing the Start/Stop button repeatedly will allow the technician to advance
through the program. If the Start/Stop button is not pressed, the program steps
are carried out automatically, in their normal order.
Note: The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.
To Next Page
Loading...
Need help?
General
