Screw the countersunk screws
(3.9 x 22) upwards through the se-
curing pieces on the left and right
hand sides into the work surface to
secure the dishwasher.
Ensure that the seal on the top
edge of the dishwasher fits directly
against the worktop. If this is not the
case, adjust the height screws
more, (see Step 2).
For “Corian” or granite worktops there
is a special accessory to fix the dish-
washer to an adjacent kitchen unit.
Pull the dishwasher approx. 5-10 cm
out of its niche.
Fit the lug of each fixing bracket into
the guide hole on top of the dish-
washer, and then swing to the left or
right side respectively.
Push the dishwasher back into the
niche, align, and fix to the adjacent
kitchen unit(s) with 2 screws (3.5 x 15)
for each bracket.
Installing integrated “i” Dishwashers
73
To Next Page
Loading...
