Problem solving guide
75
Water inlet fault
Problem Possible cause and remedy
The dishwasher
stopped working shortly
after the programme
started.
The buzzer is sounding.
The / indicator
light is flashing on and
off.
The tap is turned off.
Turn on the tap fully.
The dishwasher has
stopped during a
programme.
The buzzer is sounding.
Fault code or has
appeared in the display.
Before rectifying the problem, you must:
Switch the dishwasher off with the button.
Water intake is restricted.
Turn on the tap fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than
50kPa (0.5bar).
Seek professional advice.
To Next Page
Loading...
