Problem Possible cause Remedy
The Wash/Rinse,
Drying and End
indicator lights flash
simultaneously.
There may be a technical
fault.
–
Switch the dishwasher off
using the On/Off button K.
After a few seconds:
–
Switch the dishwasher
back on.
–
Select the programme
required with the
programme selector
button.
–
Press the Start/Stop
button.
If the programme sequence
indicator lights flash again,
there is a technical fault.
– Call the Service
Department.
The drain pump works
even when the door is
open.
The Waterproof system
has reacted.
– Close the stopcock.
– Call the Service
Department.
Problem solving guide
40
To Next Page
Loading...
