Frequently Asked Questions
57
Water intake fault
Problem Possible cause and solution
The Intake/Drain indica-
tor flashes on and off.
The water supply is turned off.
Turn on the water supply fully.
The dishwasher stops
during a program.
The Intake/Drain indica-
tor flashes.
Fault code or ap-
pears in the display.
Before fixing the fault:
Turn the dishwasher off with the button.
There is a problem with the water intake.
Turn on the water supply fully and start the pro-
gram again.
Clean the water intake filter (see "Frequently asked
questions").
The flow pressure at the connection point is lower
than 7.25 psi.
Contact a plumber.
Water drainage fault
Problem Possible cause and solution
The dishwasher stops
during a program.
The Intake/Drain indica-
tor flashes.
Fault code shows in
the display.
Before fixing the fault:
Turn the dishwasher off with the button.
There is a problem with the water intake.
There might be water in the wash cabinet.
Clean the filter system (see "Cleaning and care -
Filter system").
Clean the drain pump (see "Frequently asked
questions").
Clean the non-return valve (see "Frequently asked
questions").
Remove any kink or loop in the drain hose.
To Next Page
Loading...
