Warning and Safety instructions
13
Ther
e are electrical wires in the water inlet hose. Do not cut the
water inlet hose, even if it is too long.
The int
egrated Waterproof system offers protection from water
damage, provided the following conditions are met:
– The dishwasher is correctly installed and plumbed in.
– The dishwasher is properly maintained and parts are replaced
wher
e it can be seen that this is necessary.
– The tap has been turned off when the appliance is not used for a
longer period of time (e.g. during holidays).
The Waterproof system will work even if the appliance is switched
off. However
, the appliance must remain connected to the electricity
supply.
The wat
er pressure (flow pressure at the connection point) must
be between 30 and 1000 kPa (0.3 and 10 bar).
A d
amaged appliance could be dangerous. If the dishwasher gets
damaged, switch it off at the mains and call Miele.
The manu
facturer's warranty will be invalidated if the appliance is
not repaired by a Miele approved service technician.
F
aulty components must only be replaced by genuine Miele spare
parts. The manufacturer can only guarantee the safety of the appli‐
ance when Miele replacement parts are used.
During
installation, maintenance and repair work, the appliance
must be disconnected from the mains electricity supply.
If
the connection cable is damaged, it must be replaced with a
special cable of the same type (available from Miele) by a Miele au‐
thorised service technician only in order to avoid a hazard.
To Next Page
Loading...
Need help?
General
