Miele G4920 - Adjust Sensor wash

Programme options
61
Adjust Sensor wash
You can adjust the Sensor wash pr
o‐
gramme so that it will remove stubborn
soiling in a lightly soiled load.
 Switch the dishwasher off with the 
button, if it is switched on.
 P
ress the
Start butt
on in and, whilst
holding it in, switch the dishwasher
on using the  button.
Keep the
Start
button pressed in for
at least 4 seconds until the
Start indi‐
cat
or light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 P
ress the  button 5 times.
The  indica
tor light will flash rapidly 5
times at intervals.
The flashing sequence in the display in‐
dicat
es whether "Adjust sensor wash"
is activated or not.
–  : "Adjust sensor wash" is switched
on.
–  : "Adjust sensor wash" is switch‐
ed off.
 P
ress the
Start butt
on to change the
setting.
The setting is now stored in memory.
 Switch the dishwasher off with the 
butt
on.