Miele G5100 - Adjust Sensor Wash

Adjust Sensor wash
You can adjust the Sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button five
times.
The "Pots & pans 75 °C" indicator will
flash briefly five times at intervals.
The flashing sequence in the display
shows what the current setting is.
–
"p1": The "Adjust Sensor wash"
function is activated.
–
"p0": The "Adjust Sensor wash"
function is deactivated.
^
If you want to change the setting,
press the Start/Stop button.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Additional functions
40