Existing plumbing:
If the standard
3
/
8
" copper plumbing for
a dishwasher already exists with a
compression fitting and valve as
pictured:
^ Cut the
3
/
8
" copper tubing after the
valve.
^ Install the
3
/
8
" compression to
3
/
4
"
MHT (Male Hose Thread) adapter
(supplied with the machine), as
illustrated.
^
For any other size plumbing, buy the
correct size adapter from a hardware
store.
^
Connect the inlet hose to the existing
valve /adapter assembly.
,
WARNING - Elcetrical Hazard
Do not cut the intake hose. If the
hose is cut, the dishwasher will not
work. There will be a water leak and
you could be injured. If the hose is
too long, coil it neatly and place it
behind the machine.
Electrical wiring and components
should not come into contact with
any plumbing fixtures or hoses.
Installation
27
To Next Page
Loading...
