en - Securing a side-by-side combination
4
. . . with partition wall
The wall a between the side-by-side
appliances must be at least
5/8" (16mm) thick.
If the door hinges of the refigeration
appliances are next to each other,
you must take into account the thick-
ness of the cabinet fronts and door
handles so that the appliance doors
do not collide and become damaged
if they are opened at the same time.
If the partition wall a is narrower than
6 5/16" (160mm), you will need the
side panel heater from the side-by-
side merging kit to prevent condensa-
tion from forming and any resulting
damage (see section “Installing the side
panel heater”).
The side panel heater is attached to
the right side of the appliance that is on
the left (when seen from the front).
When planning niches, please note
that the niche into which the appli-
ance with the side panel heater is
installed must be
1/8"-1/4"(3–5mm) wider.
Connecting the side panel heater
leads to higher energy consumption.
To Next Page
Loading...
Need help?
General
