Installation
*INSTALLATION*
54
Ventilation
Risk of fire and damage due to
insufficient ventilation.
If the refrigeration appliance is not
ventilated sufficiently, the com-
pressor will run more frequently and
for longer periods. This will result in
increased energy consumption and a
higher operating temperature for the
compressor. This may, in turn, cause
damage to the compressor.
Please ensure that there is adequate
ventilation around the refrigeration
appliance.
It is essential to observe the required
ventilation gaps.
The ventilation gaps must not be
covered or blocked in any way.
They must also be regularly dusted.
Ventilation takes place through a vent-
ilation grille in the refrigeration appli-
ance plinth.
Furniture door panel
–Gap
Depending on the style of kitchen fur-
niture, the thickness and edge radius of
the furniture door and the gap that runs
around the door, vertically and horizont-
ally, are specified.
It is essential to pay attention to the fol-
lowing:
If the gap between the refrigeration
appliance furniture door panel and the
adjoining housing unit door or wall on
the hinged side is too small, the appli-
ance door could collide with the ad-
joining housing unit door or wall when
opened.
It may be necessary to adjust the
size of this gap to suit the thickness
and edge radius of the appliance fur-
niture door.
Tip: This must be taken into considera-
tion when planning your kitchen and
when replacing an old refrigeration ap-
pliance with a new one to ensure the in-
stallation conditions required are met.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
