Before building the appliance in decide
on the door hinging. If left hand door
hinging is required follow the
instructions below.
Appliance door
^
Remove cover a by hand, and
remove cover b using a screwdriver.
^
Loosen screws c in the top and
bottom hinges.
^
Remove the appliance door.
^
Remove stoppers e from the
appliance housing and replace them
with screws c. Now plug the holes
on the opposite side with stoppers
e.
^
Unscrew the hinges at the top and
bottom of the appliance door d and
refit them on the diagonally opposite
side.
Warning: Do not allow the hinges to
close. Danger of injury.
^
Tighten the hinges on the appliance
door and fit stoppers f in the holes
which are now open.
^
Refit the appliance door onto
pre-fitted screws c, then tighten the
screws.
^
Clip covers a and b on to the
hinges.
Freezer compartment door
^
Remove stoppers a.
^
Unscrew catch b.
^
Unscrew the freezer compartment
door c, turn it around and refit it on
the opposite side.
^
Remove stoppers d and fit catch c
into this position.
^
Plug the holes with the stoppers.
Changing the door hinging
32
2
To Next Page
Loading...
Need help?
General
