The appliance is supplied right hand
hinged. If left hand door hinging is
required, follow the instructions below.
Removing the door handle:
First the side section of the handle must
be removed:
^ Pull door handle a towards you. Side
section b slides back, creating a
gap d between side section b and
mounting plate c.
^
Place a suitable object (e.g. a spoon
handle) in gap d, and slowly lever
the handle towards the door.
Be careful not to let the "spoon
handle" slip, causing damage to the
appliance.
The side section b can now be
removed.
^
Pull side section b out of the guides
on the mounting plate.
^
Loosen the 4 screws (Torx 15) in the
mounting plate, and remove the
handle.
^
Remove the cover caps from the
opposite side, and fit them into the
empty holes.
Changing over the doors:
^ Remove cover a.
^ With the appliance door closed,
unscrew lower hinge bracket b and
then take the door down and off.
^
Refit cover cap d on the opposite
side.
^
Take hinge parts c out of hinge
bracket b, then refit them in the
second hole in the hinge bracket.
^
With the upper door f closed, pull
hinge pin e downwards to remove it.
^
Open the upper door, and pull it
downwards and off.
Changing the door hinging
40
To Next Page
Loading...
