Changing the jets
Normal/Fast burner
^ Using a 7 mm nut driver or socket
wrench, unscrew and remove the jet.
^
Install the new jet according to the
conversion table.
^
Save the jets and needle valves
removed from the appliance for future
use.
Wok burner
^ Use a 10 mm wrench to remove the
jet. While doing this, use a 13 mm
wrench to hold the gas tube to
prevent it from twisting.
^ Install the new jet using the same
procedure.
^
Save the jets and needle valves
removed from the appliance for future
use.
Converting KM 342 / 344
10
To Next Page
