Flush-fitted cooktops
64
Preparing the worktop
Create the worktop cut-out as shown
in the cooktop and inset diagrams.
Remember to maintain the minimum
safety distances (see "Safety
distances").
Solid wood, tiled and glass worktops:
Fix the wooden frame 7mm below
the top edge of the worktop (see
diagram).
Installing the cooktop
Feed the mains connection cable
down through the cut-out.
Centre the cooktop in the cut-out.
Connect the cooktop to the mains
electricity supply.
Check that the cooktop works.
Seal the remaining gap with a
silicone sealant that is heat-resistant
to at least 160°C.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone, and observe the
sealant manufacturer's instructions.
Please follow the manufacturer's
instructions.
To Next Page
Loading...
