Miele Optima Series - Buzzer; Default Setting

Buzzer
A signal sounds at the end of a
program and when a fault occurs.
The buzzer at the end of a program
sounds five times in quick succession
for up to one hour.
The buzzer for a fault sounds in
intervals up to two minutes.
The buzzer is activated by default. It
can be turned off, so it does not sound
at the end of a program. The buzzer for
a fault cannot be turned off.
^ Open the door.
^ Turn the dishwasher off with "o".
^ Press the program button and at the
same time turn the dishwasher on
with "g".
^ Hold the program button for at least
4 seconds until the lower right
program indicator comes on.
If it does not come on, start over.
^
Press the tab button four times.
The "Gel" indicator flashes four times in
intervals.
The time display shows if the program
end buzzer is turned on or off.
–
"p 1": Buzzer is turned on
–
"p 0": Buzzer is turned off
^
Press the program button to change
the setting.
The setting is saved.
^
Turn the dishwasher off with "o".
Default setting
All settings can be reset to the factory
default.
^
Open the door.
^
Turn the dishwasher off "o".
^
Press the program button and at the
same time turn the dishwasher on "g".
Hold the program button for at least
4 seconds until the lower right
program indicator comes on.
If it does not come on, start over.
^
Press the tab button 12 times.
The "Gel" indicator flashes once long
and twice short in intervals.
The time display shows if a setting was
changed.
–"p 1": All settings are factory default.
–"p 0": At least one setting was
changed.
^ To reset the dishwasher to the factory
default, press the program button.
The setting is saved.
^
Turn the dishwasher off "o".
Additional options
35
All manuals and user guides at all-guides.com