en - Changing the programme sequence
91
Changing a programme once it has started
You cannot change to another programme once a programme has
started (this prevents unintentional alterations). You will need to can-
cel the current programme before you can select a new one.
Risk of fire due to incorrect use and operation.
The laundry can burn and destroy the tumble dryer and the sur-
roundings.
See the section on “Warning and safety” for further information.
If you adjust the programme selector, the symbol will light up in
the time display. The symbol goes out when you select the ori-
ginal programme.
Cancelling the current programme
Touch the Start/Stopsensor control for more than 2seconds.
If the programme has ended or has been cancelled and the laundry
temperature is high enough, the items will be cooled down.
If you press the Start/Stopsensor control again during the cooling
phase, will light up.
Open the door.
Adding laundry
Open the door.
Risk of burns by touching hot laundry in the tumble dryer drum.
The laundry and the tumble dryer drum are still hot and can cause
burns if they are touched.
Let the laundry cool down and remove it carefully.
Add the laundry.
Close the door.
Start the programme.
Adding laundry during ongoing Delay start period
You can open the door to add or remove laundry.
- All programme settings will be saved.
- You can change the drying level, if required.
Open the door.
Add or remove laundry.
Close the door.
Touch the Start/Stop sensor control so that the Delay start period
continues.
To Next Page
Loading...
Need help?
General