en - Operation
47
End of programme
At the end of a programme, the in-oper-
ation indicator light will flash slowly with
the door shut. The buzzer might also
sound.
The in-operation indicator light will go
out 10minutes after the end of the pro-
gramme if the door is closed.
The programme has ended when the
display shows the message Finished.
In some programmes, if the “AutoOpen”
function is activated, the door will auto-
matically open slightly. This improves
the drying process.
If the Consumption programmable func-
tion is activated, you can now view the
actual water consumption of the pro-
gramme which has just finished.
The drying fan may continue to run for
a few minutes at the end of the pro-
gramme.
Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of worktops when
you open the door at the end of the
programme if the fan is no longer
running.
If you have deactivated the auto-
matic door opening function but
would still like to open the door at
the end of the programme, then
make sure that you open the door
fully.
Switching off the dishwasher
Open the door.
The dishwasher can be switched off
at any time using the sensor con-
trol.
Confirm the query Switch appliance off
with OK.
Switching the dishwasher off during a
programme stops the programme.
You can also do this to stop an ongoing
timer.
If you have touched the sensor
control, but in fact do not wish to
cancel the programme, use the
button to select the Do not switch off
option on the display and confirm
with OK.
Risk of damage from leaking wa-
ter.
Water leakage can cause damage.
If the dishwasher is not going to be
used for a longer period of time, e.g.
whilst on holiday, the stopcock
should be closed as a precaution.
To Next Page
Loading...
Need help?
General
