EasyManua.ls Logo

Miele Premier Plus - Adding Detergent; Correct Detergent Amount

Miele Premier Plus
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Adding detergent
All modern detergents produced for
automatic washing machines are suit-
able, including liquid, compact (con-
centrated) and special application
detergents. Use dispensing aids, e.g.
balls, if these are supplied with the
detergent. Woollens and knitwear con-
taining wool mixtures should be
washed using a detergent specifically
designed for washing woollens.
Amounts of detergent are recom-
mended on the packaging. The right
amount to dispense will depend on the
following:
The quantity of the washing.
The water hardness level (check with
your local water supplier).
The level of soiling.
Water Hardness
Hardness
range
Type of
water
(hardness)
Total
hardness
(mg/l)
°dH
(German)
I soft 0 - 130 0° - 7°
II medium 130 - 250 7° - 14°
III hard 250 - 380 14° - 21°
IV very hard over 380 over 21°
It is important to dispense the
correct amount, because...
...too little has the following results:
The washing will not be properly
clean and will in time become grey
and hard to the touch.
Greasy particles cling to the washing.
Lime deposits on the heater ele-
ments.
...too much results in the following:
Excessive foam.
Low level of agitation.
Poor washing and rinsing results.
Water is taken in through compartment
i in the pre-wash.
Water is taken in through compartment
j in the main wash. If the capacity of
compartment
j is insufficient for the
amount of detergent needed (e.g. in
very hard water areas), the Customer
Service Engineer can adjust the ma-
chine so that water and detergent can
also be taken into the main wash
through compartment
i.
Water Softeners
A water softener can be used to cut
down on the use of detergents in water
hardness ranges II-IV. Dispense ac-
cording to the amount specified on the
packaging. First add detergent and
then the water softener.
Use a quantity of detergent as for soft
water.
If you wash using several components
(e.g. special application detergents),
we recommend dispensing the agents
into compartment
j in the following
order:
1. Detergent
2. Water softener
3. Stain salts
This way the agents are distributed
more efficiently.
Adding detergent
16

Related product manuals