Problem solving guide
With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages in the display
Problem Possible cause Remedy
1
Adjust the load
The drum is empty or
the laundry is too dry.
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can also
happen if the items are
already dry.
Use the Hot air
programme (timed
drying) to dry individual
items.
To delete the message:
– Open the door.
;
Technical fault
If restart is unsuccessful,
call Service.
A fault number (e.g.
F43) might also be
displayed.
A programme cannot be
started while there is a
fault message in the
display.
– Make a note of what
is shown in the
display.
–
Try to start the
programme again.
:
Power failure
Programme stopped
Press OK button
The tumble dryer was
switched off during a
programme or there has
been a power cut.
–
Press the OK button
after switching the
dryer back on and
start the programme
again.
Problem solving guide
34
To Next Page
Loading...
Need help?
General
