Miele PT 7331 - Frequently Asked Questions; Troubleshooting Specific Faults

If the display remains off, the dryer has no
power.
^
Check the plug, the main switch and the
fuses on-site.
§
Fan fault
Program stop. Press Start.
Motor temperature too high.
f
^
Allow the motor to cool down.
m
Drive motor fault
Motor temperature too high.
Continue: Press Start.
f
^ Allow the motor to cool down.
y
Power failure
Program stop.
Press Start.
f
^
Press h "Start" to continue the program.
§
Heating system fault
Program stop. Press Start.
Program run without heating.
f
^
Press h "Start" to continue the program
without heating.
Call Technical Service.
§
Heating system fault
Call Technical Service
if restart w/o success.
f
^
Call Technical Service.
§
Pressure sensor fault
Call Technical Service
if restart w/o success.
f
^
Call Technical Service, if restart is not
successful.
§
Gas system fault
Call Technical Service
if restart w/o success.
f
If the error occurs immediately after the
program start:
^
Open the gas valve and press h "Start".
If the error occurs in the middle of a program
run, the gas pressure may have decreased
due to use of additional gas appliances.
^ Press the h "Start" button.
^ Call the Technical Service, if restart is not
successful.
§
Card error
Reinsert card correctly in card reader.
Continue with End button.
f
^
Insert the card properly into the card
reader.
Frequently asked questions
24