Programme stop
To halt the programme press the f button.
The programme remains stationary.
2 Cottons dry
Programme stop
ü f
To continue the programme press the "Start" button.
Programme cancellation
To cancel a programme press the f "Stop/End"
button twice in succession.
Changing the programme order
The order of the programme in progress can be
changed or programme blocks can be repeated.
^
Press the f button and the programme will stop.
2 Cottons dry
Programme stop
ü f
^ After pressing the ü button the current area or
block will appear in the display.
See also "Programme structure" in the Progamming
Manual.
Reorganise -> 2 Cottons dry
Programme stop
Area 1: Drying e
S A
Area 1: Drying
Block 1: Pre-drying
-
S A
^
Turn the rotary dial to select the area, and then
press it to confirm your selection.
Select Area: 1 Drying, or 2 Cooling down and
confirm your selection.
^
Turn the rotary dial to select the block and then
press it to confirm your selection.
Select Block: Drying 1-10, or Cooling down 1-10
and confirm your selection.
^
Press the S "Save" button and then press "Start" to
reorganise the programme order or press the A
"Back" button to go back to programme stop and
not change the programme order.
Programme information
Pressing the K "Information" button will call up further
information about the programme e.g.:
2 Cottons dry
Start date and time: 10.7.2009
Start time: 9:47 e
m
K
f
Time after start: 0h 23 min
Time left: 0h 11min
Progr.-End: 10: 21 h e
Area: 1 Drying
Block: 1 Pre-drying
Exhaust temperature Actual: 59 °C e
Exhaust temperature Required: 74 °C
Air intake temperature: Actual: 125 °C
Air intake temperature: Required: 150 °C e
Peak load: No
Anti-crease: 3 s./87s./60 min
Exhaust / Recirculation: Recirculation e
2 Cottons dry
Block end signal Yes -
A
^
Press the A "Back" button to return to the
programme sequence display.
Additional options
17
To Next Page
