Adjusting the telescopic tube
One part of this telescopic tube is
packed inside the other and can be
adjusted to suit your height for
comfortable vacuum cleaning.
^
Press the telescopic tube release
button to release the tubes and
adjust to the required height.
Fitting the standard floorhead a
^
Push the suction tube into the
floorhead and turn it clockwise or
anti-clockwise until it clicks into
position.
To remove the standard
floorhead b
^ To release the floorhead from the
suction tube, press the locking button
and pull the floorhead away from the
suction tube.
Adjusting the floorhead c
The floorhead can be used for all
normal cleaning of carpets and rugs.
It is also important to observe the
flooring manufacturer’s cleaning and
care instructions.
Vacuum carpets and rugs with the
brush retracted:
^
Press the foot switch
ö.
Clean hard flooring which is not
susceptible to scratching with the brush
protruding:
^
Press the foot switch
ä.
Preparing for use
10
To Next Page
Loading...
