Attaching the floorhead
^
Push the suction tube into the
floorhead and turn it clockwise or
anti-clockwise until it clicks into
position.
^
To release the floorhead from the
suction tube, press the locking button
(see arrow) and pull the suction tube
away from the floorhead.
The floorhead can be used for all
normal cleaning of carpets and rugs. It
can also be used with the brush
protruding to vacuum hard flooring. For
hard flooring, such as stone and
parquet, we recommend using one of
the special Miele floor brushes (see
"Optional accessories").
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
Vacuum carpets and rugs with the
brush retracted:
^
Press the foot control
ö.
Clean hard flooring which is not
susceptible to scratching with the brush
protruding:
^
Press the foot control
ä.
Electrobrush / Turbobrush
Some models may be supplied as stan
-
dard with an Electrobrush or a
Turbobrush in addition to the normal
floorhead (see "Optional accessories").
Please refer to the separate operating
instructions supplied with these
brushes for instructions on use and
maintenance.
Preparing for use
11
To Next Page
Loading...