When to change the thread
lifters
The thread lifters on the suction inlet to
the floorhead and the upholstery nozzle
can be replaced.
Check them from time to time and
replace them if the pile has worn down.
To replace the thread lifters
^
Use a suitable tool to remove them
from the slots.
^
Fit new thread lifters.
Upholstery nozzle, 190 mm
^ Disengage the thread lifter unit at
each side of the upholstery nozzle
using a coin.
^ Fit a new thread lifter unit and lock
into position.
If threads or hair have wound round
the bearing on the floorhead roller
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove.
c Take out the roller.
Remove any threads and hair, replace
the roller and refit the bearing.
Spare parts are available from your
Miele Vacuum Cleaner Specialist or
from the Miele Spare Parts Department
(see back cover for contact details).
Maintenance and care
32
To Next Page
Loading...
Need help?
General
