4 Service
4.1 Operating Unit Removal
A Dust Channel Assembly Removal, 030 4.3.
A Take out the exhaust filter frame (and filter).
A Cover Frame Removal, 020 4.2.
x
Warning!
To avoid damaging the lacquered surface, do not lever out the foot switch with
sharp tools (screwdriver, etc.).
A Carefully lever out the two foot switches with a lid opener (mat. no. 05012752)
(040 Fig. 8).
x
Fig. 8: Foot Switch Removal
A Remove the three T20 screws (040 Fig. 9, Pos. 1).
A Take out the parking slot trim (it will come out on its own).
A Release the two front clips and one side clip with a small flathead screwdriver
(040 Fig. 9, Pos. 2), and remove the operating unit.
Descriptive Technical Documentation
040-8 DTD no. 41-8000
This information should not be duplicated or passed on without Miele approval. All rights reserved. 07.06.2013, US_am
To Next Page
Loading...
