Replacing the seal on the dust box
^
Press the dust box release button
and remove the dust box.
^ Unclip the seal from the bottom of the
dust box and carefully swing it out
until it detaches from the dust box.
^ Attach the new seal to the side and
clip it into position.
^
Replace the dust box in the robot
vacuum cleaner, making sure if clicks
into position.
Cleaning the front wheel
^
Place the robot vacuum cleaner
upside down on a level, clean
surface.
Do not lift the robot vacuum cleaner
by the area around the dust box as
it can come loose.
^
Unclip the cover.
^
Remove the front wheel.
^
Remove any threads and hairs and
clean the front wheel with the brush
end of the cleaning brush.
^ Replace the front wheel and close
the cover making sure it clicks into
position.
Cleaning the sensors
^
Carefully clean the sensors on the
side and the bottom of the robot
vacuum cleaner using a dry cotton
wool bud.
en
48
To Next Page
