Miele SLQL0 - Page 57

21
 Press the Mode button repeatedly
until the symbol for the vacuuming
mode you want flashes on the dis-
play.
 Press the OK button to confirm your
selection.
The settings are shown for approx.
three seconds on the display. The robot
vacuum cleaner will now start to va-
cuum at the same time each day.
If the timer  indicator is lit up in the
display, then the timer is activated.
To alter the entries, proceed as de-
scribed above.
Deactivating the timer
 Press the Timer button on the remote
control briefly.
The timer  indicator goes out on the
display.
Activating the timer / displaying a set
start time
 Press the Timer button on the remote
control briefly.
The timer  indicator lights up in the
display and the set start time is shown
briefly in the indicator field. The robot
vacuum cleaner will start to vacuum at
the set time.
Deactivating the acoustic signals
Acoustic signals are set as standard.
You can deactivate and then reactivate
them.
 Press the Mute button on the remote
control briefly.
OFF will appear in the indicator field
briefly.
Acoustic signals for error messages
cannot be deactivated.
Reducing the maximum crossing
over height
The robot vacuum cleaner is set to
overcome height differences of up to
17mm as standard. It is therefore able
to vacuum carpets, move over door
thresholds, etc.
If you would like to reduce this height
(down to approx. 6mm) in order to pro-
tect the legs of chairs, tables or lamps,
for example, you can deactivate the
factory default setting.