Problem Possible cause Remedy
The Clean the filters
indicator light
comes on at the end
of the programme.
This is a reminder to
clean the fine filter in front
of the heat exchanger unit
under running water.
–
Clean the fine filter.
–
See chapter "Cleaning and
care".
–
The indicator light goes out
once the fine filter has been
removed and refitted while
the dryer is switched on.
~F~ lights up and a
programme cannot
be started.
The fine filter is not in
place or has been
incorrectly fitted.
–
Correctly fit the fine filter:
~F~ will go out.
–
See chapter "Cleaning and
care".
The programme will be
cancelled if the fine filter
is removed while the
machine is in operation:
Cooling down is flashing.
–
Fit the fine filter.
– Switch the dryer off and
then on again.
The following
flashes at the end of
a programme:
—œ–...C~–...Cœ˜....
The programme has
finished but the laundry is
still cooling down.
You can remove the laundry
and spread it out to allow the
heat to dissipate, or leave it in
the dryer to cool down more.
The programme is
cancelled.
The buzzer may
sound and Cooling
down or Finish is
flashing.
There is no immediate
cause.
– Switch the dryer off and
then on again.
–
Start a programme.
If the programme stops again
and Cooling down or Finish
flashes again, there is a fault.
Contact Miele.
The indicator light
Start/Stop flashes
slowly and the
display is dark.
The dryer is in standby.
This is a normal function
and does not indicate a
fault.
See "Setting standby" in
"Programmable functions".
The Start/Stop
indicator light
flashes / lights up.
The flashing indicates
that a programme can be
started.
After the programme has
started, the flashing will
change to a constant light.
Problem solving guide
34
To Next Page
Loading...
Need help?
General
