Problem Possible cause Remedy
There are humming
noises.
The compressor is
operating.
None. These noises are quite
normal and do not indicate a
fault.
The display is dark.
The programme
selector is not lit up.
The Start/Stop button
light flashes slowly.
The display has
switched off
automatically to save
energy (Standby
mode).
The light of the
programme selector
goes out when
selecting Settings J.
The display will light up when
one of the buttons is pressed.
The Start/Stop
indicator light
flashes/does not flash.
The flashing indicates
that a programme can
be started.
After the programme has
started, the flashing will
change to a constant light.
A programme cannot
be started.
There is no immediate
cause.
– Is the dryer switched on?
– Is the mains plug plugged
in?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
–
If you cannot remedy the
problem, there is a fault.
Call Miele.
Power cut. When power is restored to the tumble dryer after a
power cut, the programme will continue automatically.
The display is in a
different language.
A different language
has been selected.
Set the language you want.
The flag symbol J will guide
you.
The interior drum
lighting is not
switched on.
The lighting switches
off automatically (to
save energy).
–
Switch the dryer off and
then on again.
–
If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
Problem solving guide
44
To Next Page
Loading...
Need help?
General