Problem solving guide
47
Problem Cause and remedy
The indicator light
comes on. and
continue to flash after a
programme has been
cancelled despite thor-
ough cleaning.
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the fault
message appears again. It is likely that the filter con-
tains residue further down inside that could not be
removed.
To deactivate the message, turn the programme
selector to the position.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in “Problem solving guide – Checking the heat ex-
changer”.
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in “Problem solving guide – Replacing the
plinth filter”.
If the plinth filter is not out of shape or damaged,
you can reactivate it in a washing machine. Follow
the instructions described in “Problem solving
guide – Reactivating the plinth filter”.
and another number
combination flash after
a programme has been
cancelled, a signal
sounds
No obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact the Miele
Service Department.
To Next Page
Loading...
Need help?
General
