Problem solving guide
31
Problem Cause and remedy
The S
tart indicator light
flashes slowly and the
display is dark.
The dryer is in standby mode. This is a normal
fun
ction and does not indicate a fault.
See
"Standby" in "Programmable functions".
The Cl
ean out airways
indicator light comes on
at the end of a
programme.
There is a build-up of fluff in the airways.
Cl
ean the fluff filters
Clean the condenser unit
Open and close the door whil
e the dryer is
switched on. The indicator light will go out.
The programme is
cancelled and the Clean
out air
ways indicator
light comes on.
An excessive amount of fluff has built up.
Clean
the fluff filters and condenser unit.
Op
en and close the door while the dryer is
switched on. The indicator light will go out.
Bars flash in the display
at the end of a
pr
ogramme:
.........
The programme has finished but the laundry has not
yet cooled down.
Either r
emove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
lights up The programme selector has been moved.
Select the orig
inal programme. The time remaining
will appear in the display again.