Frequently Asked Questions
Other problems
Problem Possible cause and solution
You can hear operating
noises (buzzing/
humming).
This is not a fault. The compressor is operating.
These noises are quite normal and can be heard
when the compressor is operating.
A program does not
start.
There is no obvious cause.
Connect the power plug.
Turn on the tumble dryer.
Close the door.
Check whether the fuse has tripped.
Power outage? When power is restored, any
previously running program will restart automatically.
Only the Start/Stop
sensor button is
flashing.
10minutes after the end of the program, the Start/
Stop sensor button will begin to flash and the display
will go out to save energy. This is not a fault, but a
normal function.
The drum will turn at intervals in the Anti-crease
phase.
Touch a sensor button to switch on the indicators.
See “Programmable functions“, “ Display switch-off
status”.
The tumble dryer is
switched off at the end
of the program.
The dryer switches off automatically to save energy.
This is not a fault, but a normal function.
To switch the dryer on, select a program.
The interior drum
lighting does not come
on.
The drum lighting switches off automatically ...
... when the door is closed.
... after a few minutes when the door is open to save
energy.
The drum lighting will come on when the door is
opened if the dryer is switched on.
50
To Next Page
Loading...
Need help?
General
