Connection to the water supply
The machine should be connected to a
mains water supply in accordance with
local and national safety regulations.
The German authorities do not require it
to have a non-return valve as the
washing machine has been designed
to comply with DIN regulations.
The machine is designed to operate
with a flow pressure of between 1 and
10 bar. If it is higher than 10 bar it is
essential to fit a reducer valve.
Connection to the mains water supply
should incorporate a mains stopcock
with
3
/
4
" thread. The stopcock should
be fitted by a qualified plumber.
,
The connection point is subject
to mains water pressure. Turn on the
stopcock slowly and check for leaks.
Correct the position of the washer
and union if appropriate.
The washing machine is not suitable
for connection to a hot water supply
and connection to a household
water softener is not recommended.
Maintenance and care
Only use a genuine Miele hose should
you ever need a replacement or
extension. These are tested to
withstand pressure of at least 70 bar.
The dirt filter in the union at the open
end of the inlet hose must not be
removed.
Installation
52
To Next Page
