Follow steps A to G to programme
and store a setting in memory.
Before you begin, first ensure that:
–
The washing machine is switched off.
–
The machine is properly closed.
–
The programme selector is at
Finish
.
A Press the START button and keep it
pressed in whilst carrying out steps
B to C.
B Switch the machine on with the
I-ON/0-OFF button.
C Wait until the START indicator light
comes on . . .
D . . . and then release the START
button.
E Turn the programme selector to the
COTTONS 75°C position:
The
Soak/Pre-wash
sequence
indicator light will briefly flash twice in
2 second intervals, to show that
factory Setting 2 is stored in memory.
F Each subsequent press on the
START button selects a different
setting.
The
Soak/Pre-wash
sequence indicator
light will flash:
–
x 1 = Setting 1
higher rinse water level selected
– x 2 = Setting 2
higher water level in the main wash
and rinses (factory setting)
– x 3 = Setting 3
extra rinse in the
COTTONS programme
– x 4 = Setting 4
higher water level in the main wash
and rinses and an extra rinse in the
COTTONS programme
G Switch the washing machine off with
the I-ON/0-OFF button.
The
Water plus
button has now been
allocated the setting you have chosen.
This setting will remain in memory until
another setting is programmed.
Programmable functions
61
To Next Page
Loading...
