Standby Q
To save energy, the display goes out
after 10 minutes and the indicator
light for the
Start/Stop
button will start
flashing slowly.
There are two options:
On
Standby is activated:
–
if a programme is not selected after
the machine has been switched on.
–
after a programme has started.
– at the end of a programme.
Not in current Prog.
(the machine is
delivered with this option selected)
Standby is activated:
– if a programme is not selected after
the machine has been switched on.
– at the end of a programme.
Pressing one of the buttons switches
the display back on again.
A tick L will appear beside the option
to show that it has been set.
Memory V
If an extra option has been selected
for a programme, or the
recommended temperature or spin
speed has been altered, the machine
will store the changes in memory at
the start of a programme.
When this programme is chosen again
these settings will appear in the display.
The machine is delivered with the
memory function deactivated.
A tick L will appear beside the option
to show that it has been set.
To close the Settings menu
C
Back A
Language F
Time ... H
^ Select
Back
and confirm your
selection.
Settings menu J
65
To Next Page
