Why does my Miele W 502 Washer programme not start?
The program may not start due to a couple of reasons. First, ensure the washer is receiving power by checking that the mains plug is properly plugged in and that the fuse or circuit breaker hasn't tripped. Also, make sure the washing machine has been prepared for first use as described in the section "Before using for the first time".
What to do if the Miele W 502 wash programme stops and a fault indicator light comes on?
If the wash program stops and a fault indicator appears, several issues could be the cause. First, the water outlet might be blocked, so clean the fluff filter and drain pump. Ensure the drain hose isn't fixed higher than 1 meter. Check that the water inlet isn't blocked by opening the stopcock, and clean the filter in the water inlet hose if it's dirty. If the water protection system has activated, you will need to call the Service Department. In case of a general fault, restart the program. If the fault indicators reappear, contact the Service Department.
General| Capacity | 5 kg |
|---|---|
| Energy Efficiency Class | A |
| Spin Speed | 1200 RPM |
| Type | Front Load |
| Loading Type | Front Loading |
| Dimensions (H x W x D) | 850 x 595 x 580 mm |
Covers correct usage, supervision, electrical safety, and basic technical checks.
Guidance on installation location, preventing flooding, and foreign objects.
Identification and function of main controls, buttons, and indicator lights.
Steps to prepare the machine for its first wash cycle, including a test run.
Troubleshooting when the programme does not start or stops with fault indicators.
Interpreting fault lights like Excess detergent, Main wash, or Anti-crease/Finish.
Troubleshooting why the drum door won't open due to power, water, or engagement issues.
Procedure for draining water when the drain outlet is clogged or opening the door manually.
Guidance on choosing a suitable floor and positioning the machine.
Step-by-step instructions for removing transit covers and bars.
Detailed illustration of how to turn and withdraw transit bars using a spanner.
Instructions for fitting covers and securing transit bars to the machine for transport.
How to ensure the machine is level using adjustable feet and a spirit level.
Explanation of the system components protecting the machine from water damage.
Requirements for connecting to the water supply, including stopcock and pressure.
Methods for connecting the drain hose to sinks, standpipes, or floor gullies.
Instructions for safe electrical connection, including wiring colours and earthing.
To Next Page
