Problem solving guide
53
General problems with the washing machine
Problem Cause and remedy
At the end of the
programme there is still
liquid in the capsule.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
Clean the small pipe.
This is not a fault.
For technical reasons a small amount of water will
remain in the capsule.
There is water next to
the capsule in the fabric
conditioner
compartment.
The Cap sensor was not activated or an empty
capsule was not removed at the end of the last
programme.
Make sure that you remember to activate the Cap
sensor the next time you insert a capsule.
Remove and then dispose of the empty capsule at
the end of each programme.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
Clean the small pipe.
The display is in a
different language.
A different language has been selected in "Settings,
Language ".
Set the language you want. The flag symbol will
guide you.
The display is dark. The display has switched off automatically to save
energy (Standby mode).
Press a button. Standby comes to an end.
To Next Page
Loading...
