Miele WSD023 WCS - Programmable Functions; Opening the Programming Level; Choosing and Selecting a Programmable Function

Programmable functions
72
The programmable functions are used
to alter the washing machine’s elec-
tronics to suit changing requirements.
Programmable functions can be
altered at any time.
Opening the programming
level
Programming is carried out in 8steps
(, , ...) using the sensor con-
trols.
Prerequisites:
- The washing machine is switched on
(the programme selector is pointing
to a wash programme).
- The washing machine door is open.
 Touch the Start/Add laundrysensor
control and hold it down while carry-
ing out steps –.
 Close the washing machine door.
Wait until the Start/Add laundry sensor
control lights up constantly...
 ...and then release the Start/Add
laundry sensor control.
After approximately 4seconds,  will
light up on the time display.
Choosing and selecting a pro-
grammable function
The number of the programmable
function will appear in the time display
as and a number: e.g..
 Touch the or sensor control to
scroll to the next or previous pro-
grammable function:
Programmable functions
 Buzzer duration
 Buzzer
 Keypad tone
 PIN code
 Control field switch-off behaviour
 Memory
 Additional long pre-wash – Cottons
 Gentle action
 Reduced temperature
 Water plus
 Water plus level
 Maximum rinse level
 Suds cooling
 Anti-crease
 Low water pressure
 Display brightness dimmed
 Operating hours
 Factory default
 Confirm the selected programmable
function by touching theStart/Add
laundry sensor control.