E Add detergent
The load size indicator display will be
replaced with the detergent percentage
display.
Detergent 75%
A
40%
Add slightly less than half the
amount recommended . . .
50%
Add half the amount
recommended . . .
60%
Add slightly more than half the
amount recommended . . .
75%
Add three quarters of the
amount recommended . . .
100%
Add the full amount
You also need to take the level of
soiling and water hardness into
account.
too little detergent results in:
–
Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–
Greasy particles clinging to the
laundry.
–
Limescale deposits on the heater
elements.
too much detergent results in:
–
Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
–
High water consumption (an
additional rinse cycle will
automatically switch in).
–
A burden to the environment.
^ Pull out the detergent drawer and
add detergent to the compartments
as follows:
i = Detergent for the pre-wash
(
1
/
4
of the total amount
recommended). This
compartment is also used for
starch formulations when
starching separately.
j = Detergent for the main wash
including Soak
§ = Fabric conditioner or liquid
starch
^
Close the detergent drawer.
See "Detergent" for further information.
WASHING
18
To Next Page
Loading...
Need help?
General
