A fault indicator lamp comes on but the wash programme
continues as normal.
Problem Possible cause Remedy
The Water inlet/drain
indicator lamp
flashes during a
programme, but the
wash programme
has run normally.
There is a blockage in
the water inlet.
Check whether:
–
the stopcock is opened
wide enough.
–
the inlet hose is kinked.
The water pressure is
too low.
–
In this case, call the Miele
Service Dept.
The filter in the water
inlet hose is dirty.
–
Clean the filter as described
in "Cleaning and care".
The Water inlet/drain
indicator lamp is
flashing.
There is a blockage in
the water outlet.
– Clean the fluff filter and the
drain pump.
– Has the drain hose been
fitted too high? Max.
delivery head 1 m.
The Drying overload
indicator lamp is
flashing towards the
end of a drying
programme.
The load was too large. – In future do not exceed the
maximum load. This way
you will avoid:
a) Creasing of
delicate textiles
b) Uneven drying
results / damp laundry
Complete the drying process
using a TIMED DRYING
programme.
The Anti
crease/Finish
indicator lamp is
flashing and the
locked indicator
lamp is on.
The selected
programme was altered
with the safety lock
activated.
See section "Safety Lock".
Problem solving guide
46
To Next Page
Loading...
