Mikasa MVH-408 Series User Manual

38 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

FOR MORE INFORMATION

CONTACT US ON 1300 353 986 OR VISIT ﬂextool.com.au

EXCLUSIVE TO

SERVICE MANUAL

Version 2.0 (August 2022)

MIKASA REVERSIBLE PLATE COMPACTOR

MVH-308GH, MVH-308DSY, MVH-508DSZ

Table of Contents

Questions and Answers:

L
lindapierceAug 9, 2025
How to troubleshoot electricity not reaching the high voltage cable in Mikasa Construction Equipment?
- T
  Terry DavisAug 9, 2025
  To troubleshoot electricity not reaching the high voltage cable, consider the following potential causes and solutions: * Bridging the igniter plug. * A short circuit may occur due to insulation problems of the igniter plug, especially if carbon has accumulated on it. * Other possible causes include an inappropriate spark gap, a short circuit in the ON-OFF switch, ignition coil problems, dirt on the point or an inappropriate gap, or breakage/short circuit of the ignition coil.
D
David GallegosAug 18, 2025
What to do if compression is good, but Mikasa Construction Equipment is not firing?
- J
  James WrightAug 18, 2025
  If your Mikasa Construction Equipment has good compression but isn't firing, several factors could be at play. It could be due to water mixed in the fuel, in which case you should drain the fuel system and replace it with fresh fuel. Another cause might be a dirty igniter plug, which should be cleaned or replaced. Inspect the ignition coil for any issues, and replace it if necessary. Finally, check for any occasional short circuits in the ignition coil and rectify them.

Mikasa MVH-408 Series Specifications

General

Brand	Mikasa
Model	MVH-408 Series
Category	Construction Equipment
Language	English

Related product manuals

Preview: Mikasa MVH-308 Series

Mikasa MVH-308 Series

Preview: Mikasa MVH-508 Series

Mikasa MVH-508 Series

Preview: Mikasa MRH-600DSA-DX

Mikasa MRH-600DSA-DX