Mikasa MVH-508 Series

Questions and Answers

L
leeandreaAug 8, 2025
How to troubleshoot electricity not reaching the high voltage cable in Mikasa Construction Equipment?
- L
  Lindsay SloanAug 9, 2025
  To troubleshoot electricity not reaching the high voltage cable, consider the following potential causes and solutions: * Bridging the igniter plug. * A short circuit may occur due to insulation problems of the igniter plug, especially if carbon has accumulated on it. * Other possible causes include an inappropriate spark gap, a short circuit in the ON-OFF switch, ignition coil problems, dirt on the point or an inappropriate gap, or breakage/short circuit of the ignition coil.
R
Ronald DominguezAug 19, 2025
What to do if compression is good, but Mikasa MVH-508 is not firing?
- L
  Lisa AndradeAug 19, 2025
  If your Mikasa Construction Equipment has good compression but isn't firing, several factors could be at play. It could be due to water mixed in the fuel, in which case you should drain the fuel system and replace it with fresh fuel. Another cause might be a dirty igniter plug, which should be cleaned or replaced. Inspect the ignition coil for any issues, and replace it if necessary. Finally, check for any occasional short circuits in the ignition coil and rectify them.
S
Stephanie HolmesAug 29, 2025
Why is the recoil starter operation not good on my Mikasa MVH-508 Construction Equipment?
- K
  Kevin Powell Jr.Aug 29, 2025
  There are several reasons why the recoil starter operation might not be working well on your Mikasa Construction Equipment. It could be due to inappropriate governor adjustment, so adjust the governor settings. Governor spring problems can also cause this issue, so replace or repair the governor spring. Additionally, check for proper fuel flow by inspecting and cleaning the fuel system. Air taken from the intake pipe system can also cause problems, so seal any leaks in the intake system. Clogging of foreign materials at the rotating part can also be a factor, so clean the rotating parts. Finally, weakening of the spiral spring can cause issues, so replace the spiral spring.