MikroTik AP User Manual

3. Connect the second ethernet cable to Port 5 of the NC as show below.
4. Perform a Factory Reset of the AP: Hold down the AP reset button (circled below, this
may require a paper clip or other small object to reach) and THEN connect the other
end of the ethernet cable in Port 5 of the NC to the AP’s ethernet port as shown below. The
reset button must be held down BEFORE connecting the ethernet cable.
NOTE: If the reset button is held down too long the LED will turn solid. If this happens,
unplug the ethernet cable and perform another factory reset.

MikroTik AP Specifications

General

Brand	MikroTik
Model	AP
Category	Network Hardware
Language	English