MikroTik hAP mini RB931-2nD

To Next Page

hAP mini

hAP mini RB931-2nD

The hAPis a simple home wireless access point. It is already configured, you can simply plug in your ISP cable and start using wireless internet. We

recommend you set up a password to secure your device.

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing

accidents.

Ultimate disposal of this product should be handled according to all national laws and regulations.

The Installation of the equipment must comply with local and national electrical codes.

This unit is intended to be installed in the rackmount. Please read the mounting instructions carefully before beginning installation. Failure to use the

correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.

This product is intended to be installed indoors. Keep this product away from water, fire, humidity or hot environments.

Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.

Read the installation instructions before connecting the system to the power source.

We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your

own risk!

In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.

It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling

requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.

This is a class A device. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate

measures.

Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC, IC, and European Union radiation exposure limits set forth for an

uncontrolled environment.This MikroTik device should be installed and operated no closer than 20 centimeters from your body, occupational user, or the

general public.

Setup

Choose your powering solution, please see the section for possibilities.Powering

Connect your internet cable to the first port, and, if you have wired devices, connect them to the other ports

Set your computer IP configuration to automatic (DHCP).

From your PC or smartphone, connect to the wireless network name which starts with "MikroTik".

Once connected to the wireless network, open in your web browser to start configuration, user name: a and there is no https://192.168.88.1

dmin

password by default.

Main Page

Need help?

Do you have a question about the MikroTik hAP mini RB931-2nD and is the answer not in the manual?

MikroTik hAP mini RB931-2nD Specifications

General

Product Code	RB931-2nD
Category	Wireless Access Point
CPU	QCA9533
CPU nominal frequency	650 MHz
RAM	32 MB
Architecture	MIPSBE
Operating System	RouterOS
License level	4
Wireless Standards	802.11b/g/n
Wireless Frequency	2.4 GHz
Wireless Speed	Up to 300 Mbps
Wireless chip model	QCA9533
Power Supply	5V DC
Storage	16 MB