If you need help with configuration, please seek a consultant https://mikrotik.com/consultants
First steps:
Make sure your Internet service provider is allowing hardware change and will issue an automatic IP
address;
Connect your ISP cable to the first Ethernet port;
Connect the device to the included power adapter;
Connect your computer to the wireless network;
Open https://192.168.88.1 in your web browser to start the configuration;
User name: admin and there is no password by default;
Configure the device, so it has an active Internet connection https://mt.lv/configuration;
Upgrade the RouterOS software to the latest version https://mt.lv/upgrade;
The device will reboot;
Connect again and choose your country on the left side of the screen, to apply country regulation
settings;
Set up your wireless network password, the password must be at least eight symbols;
Set up your router password in the bottom field to the right and repeat it, it will be used to log in next
time.
Safety Information:
Before you work on any MikroTik equipment, be aware of the hazards involved with electrical
circuitry, and be familiar with standard practices for preventing accidents. The installer should be
familiar with network structures, terms, and concepts.
Use only the power supply and accessories approved by the manufacturer, and which can be found in
the original packaging of this product.
This equipment is to be installed by trained and qualified personnel, as per these installation
instructions. The installer is responsible for making sure, that the Installation of the equipment is
compliant with local and national electrical codes. Do not attempt to disassemble, repair, or modify the
device.
This product is intended to be installed indoors. Keep this product away from water, fire, humidity, or
hot environments.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device.
Please use this product with care and operate at your own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging
the power adapter from the power outlet.
To Next Page
Loading...
Need help?
General
