MikroTik SXT 4G kit - User Manual

1.
2.
3.
4.
5.
SXT kit-series
SXT kit series models:
SXT 4G kit
SXT LTE6 kit
SXT LTE kit-US
SXT LTE kit
The SXT kit comes as a complete set and includes a built-in modem, connected to a built-in antenna. It has two 10/100 Ethernet connectors that support
MDI-X auto-detection. There are two micro SIM card slots available, to switch between cell providers.
First use
The default configuration is CPE RouterMode:
*LTE interface connected to providers network (WAN port);
*WAN port is protected by a firewall and enabled DHCP client.
LAN Configuration:
IP Address 192.168.88.1/24 is set on the bridge (LAN port)
DHCP Server enabled;
DNS: enabled.
WAN (gateway) Configuration:
gateway: lte1;
ip4 firewall: enabled;
NAT: enabled.
Open the bottom lid.
Insert the SIM cards into the micro-SIM slots (SIM A slot is a default).
If using another slot, the configuration can be changed in RouterOS with CLI command:
/system routerboard modem set sim-slot=down
After changing SIM slots, LTE modem will be restarted. It can take some time (depending on modem and board around 30 seconds) to fully
initialize it, so make sure you test your modem.
https://wiki.mikrotik.com/wiki/Dual_SIM_Application
Connect the device to the power source (see " ").SXT kit-series#Powering
Once the device is powered on and PC connected to the device, open in your web browser or Winbox to start the https://192.168.88.1
configuration.
User name: a and there is no password by default you will be logged in automatically to the Quick Set screen. dmin

MikroTik SXT 4G kit Specifications

General

Product Name	SXT 4G kit
Category	Network Router
Architecture	MIPSBE
Size of RAM	64 MB
Storage size	16 MB
Storage type	Flash
Operating system	RouterOS
Wireless Standards	802.11b/g/n
Frequency Range	2.4 GHz
Max Data Rate	150 Mbps
Ethernet Ports	1
Power Supply	Passive PoE
PoE in	Yes
PoE out	No
Operating Temperature	-40°C to 70°C
4G LTE Support	Yes
Number of SIM slots	1
4G Category	LTE Category 4

Summary

First Use

LAN Configuration

WAN Configuration

SIM Card Insertion

Inserting micro-SIM cards into slots and configuration command for dual SIM.

Initial Access and Login

Access the web interface at 192.168.88.1 with default credentials.

Software Updates and Password Setup

Mounting

Pole Mounting Procedure

Steps for attaching the mounting bracket, clamp, and unit to a pole.

Installation Safety Precautions

Grounding

Powering

Powering via Ethernet

Device accepts power from Ethernet port (PoE ETH1) and notes power consumption.

Connecting to PoE Adapter

Configuration

Extension Slots and Ports

Reset Button Functions

Instruction Manual (English)

Connecting Power and Accessing Device