To Next PageTo Next Page
Need help?Do you have a question about the Mikuni MX40 and is the answer not in the manual?
Guidance on selecting an appropriate location for the heater, considering factors like storage, weather, and proximity to fittings.
Details on how the 'MX' Heaters can be used to heat radiators, matrix heaters, or a calorifier for domestic hot water.
Lists the essential tools required for installing the Mikuni heater, including drills, spanners, and cutters.
Specifies recommended plastic plumbing sizes (22mm main, 15mm T-off) and the importance of water flow.
Instructions for mounting the MX40 heater, including its pre-wired plate, anti-vibration mounts, and fixing to a vertical bulkhead.
Guidance on mounting the MX60 heater, typically on a horizontal surface, with options for vertical bulkhead installation.
Procedure for drilling and fitting a brass skin fitting for the exhaust outlet, emphasizing placement above the waterline.
Steps for fitting a stainless steel skin fitting, including drilling at an angle and securing with bolts and sealant.
Detailed steps for connecting the copper fuel line, including fittings, fuel pump, and solenoid valve for the heater.
Instructions for connecting the MX40 heater's battery supply, switch, and timer/thermostat using pre-wired looms.
Details on connecting the MX60 wiring loom, ensuring correct plug connections and common negative for neutral wires.
Illustrates plumbing circuit layouts for both pressurized and gravity systems, showing heater, calorifier, and water flow.
General